Thingmagic Nomad RFID Setup Guide Manuel d'utilisateur télécharger pdf (Page 10)

10 Nomad RFID Reader Setup Guide

RFIDSearchLightInstaller.CAB window

The installer installs the following files:

 RFIDSearchLightInstaller.CAB

 RFIDSearchLight.CAB

 FtdiVcpInstaller.CAB

 NETCFv35.Messages.EN.wm.CAB

 NETCFv35.wm.armv4i.CAB

After each component is installed, you have to press

“OK” in the top-right hand corner to install the next

component.

NOTE: You must restart the Nomad after installation.

7. After each component is installed, click on the OK button in the upper right of each

window. When the process completes, you must the restart the Nomad.

8. Click on the Start button in the Windows main menu. The Start dropdown menu

displays.

9. Plug the RFID Reader’s USB cable into the Nomad.

10. Go to the Before Running the RFID SearchLight Software, before using the RFID

SearchLight application.

Nomad connector panel (bottom of unit)

With RFID Reader connected to USB port.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Pas de commentaire

Thingmagic Nomad RFID Setup Guide Manuel d'utilisateur Page 10