Thingmagic Astra-EX Manuel d'utilisateur télécharger pdf (Page 69)

Mounting the Reader

M6 and Astra-EX User Guide 69

Mounting the Reader

See Appendix B: M6 and Astra-EX Dimensions for mounting hole locations and

dimensions.

CAUTION!

If there is any chance of dust or water exposure, the Astra-EX should be

mounted with the Ethernet, USB, Console, Power and GPIO ports facing

down to prevent ingress.

When mounting the M6 reader it is recommended to use four #10 x ? in. min. screws or

M5 x 20 mm screws, with washers min. ? in. in diameter. Nylon plastic expansion wall

anchors shall be suitable for the screw size. The mounting surface should be minimum ?

in. drywall. If mounting to the ceiling use nylon hollow wall anchors suitable for the screw

size and application. As an alternative, # 10 x 1-1/2 in. screws and washers may be used

if mounting directly to a wall stud.

Follow these steps to mount the reader on a ceiling or wall:

1. Hold the reader in its mounting location and mark the position of the four

mounting screws.

2. Drill holes for the screws and install wall or ceiling anchors if required. For ceiling

mount, use only anchors specifically designed for ceilings.

3. Hold reader over holes and insert the screws and tighten until almost flush with

the wall.

4. Tighten the screws.

Astra-EX

When mounting the Astra-EX Reader it is recommend to use an NRTL approved VESA

100 mount, following the standard mounting procedure of the VESA mount referencing

the Astra mounting hole locations as shown in Figure 22.

Alternatively you can use the centered Tripod mounting hole for 1/4"- 20 screws. This is

for use with tripods shorter than one meter.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 89 90

Pas de commentaire

Thingmagic Astra-EX Manuel d'utilisateur Page 69